Free Shipping on orders over 50$
Welcome to Army Surplus Warehouse
Now Stainless Steel and Easier to install.
Still the Real Deal. Still High Quality. And still the Best and Easiest way out there to "Make your ammo can - Lockable and Safe. "
The padlock stud is now a one piece design (post and thread together). Made from Solid (1/2") machined STAINLESS 303 STEEL. Made right here in the good old US of A. (Could of done it cheaper overseas but why??). The stud is secured with a nylon locknut that is Grade 8 hardened steel (zinc plated) thus eliminating the need for any thread locking compound. With this Nylon Locknut the bad guy can spin it all day long and the nut will not back off ( the bad guy nut will though). The watertight integrity of the can stays intact because we now include a Neoprene Washer that goes on the inside (or outside) . The large washer is now Stainless Steel. (So all parts exposed to the elements are now Stainless Steel.) The small washer is all steel and zinc plated for rust protection. The padlock stud will take up to a 1/4" lock shackle. Overkill, but once again why scrimp when security is your goal? Installation involves drilling one 11/32"or 5/16" hole, put on the neoprene washer, then the small metal washer, then the locknut and you are Done.
Will work on all Ammo can lids. Slotted lids ( slotted lids require two ), Big hole lids, and Small hole lids. For the small hole lids some minor fitting may be needed. Very Minor. The stud is now a true 1/2" so any filing will be very minor as the lid hole is a 1/2" too. If you have a slotted lid or a large hole lid then NO filing/fitting will be needed.
Kit includes: The Stainless Steel stud, One large Stainless Steel washer, One small washer, One neoprene washer , One Grade 8 nylon locknut, and instructions.
(*Lock and Can - Not included.*)
INSTALLATION TIP: On the 50 cal cans with the small hole latches , close the latch and use a 1/2” bit to lightly drill through the latch hole . DO NOT DRILL THROUGH THE CAN, But just enough to scratch the surface. This will leave a mark which will be the exact center to start your 5/16” hole.Learn More